How To Turn Maintenance Light Off Toyota Highlander. Step 1 turn the ignition switch to the on position but do not crank the engine. To reset the 2016 toyota highlander maintenance light after an oil change, please follow these instructions:
Step 2 press the odo/trip button to display to odo. Toyota highlander maint reqd light nearly every make and model year of toyota vehicle has the same process to reset the maintenance required light. The engine should be turned off.
Table of Contents
Press And Hold The Odometer Button.
Toyota highlander maint reqd light nearly every make and model year of toyota vehicle has the same process to reset the maintenance required light. Turn the ignition to the “ acc ” or “ lock ” position. How do you turn off the maintenance required light on a 2015 toyota highlander?
Turn The Key To The On Position With The Odometer Showing.
I have a toyota highlander 2007, my maintenance record light has been on all day, i checked the oil, it was fine, i also checked the gas tank to make sure it was closed properly, it was. This will reset the light and it will turn on again in a few thousand miles to remind you to service your car again. While holding down the trip meter reset knob turn the ignition to run (one position before starting engine).
Turn The Key To The On Position.
How do you turn off the maintenance required light on a toyota push start? In this section, i’ll show you how to reset the maintenance required light on toyota highlander with the trip button. Put the ignition in “on” without cranking the engine, press and hold the odometer button until the total mileage shows on the display, then turn off the ignition, press and hold the odometer button, turn the ignition on and then release the odometer button when the light blinks and stops.
Move The Key In To The Run Position If You Have An Engine Start Stop Button Then Press That Once.
Hold down knob for at least 5 seconds. Now press the trip button until trip meter a is showing and then kill power to the vehicle. Hold in the same button you used in step 1.
If Your Vehicle Has An Ignition Button, Press The Start/Stop Button Two Tomes Without Step On The Brake Pedal.
Ensure trip metre a reading is shown. Press and hold the odometer button. The engine should be turned off.
