How To Reset Balboa Hot Tub Control Panel. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is. Before you call out a balboa service technician, though, try to do some.
This is known as a topside control panel. Turn on your spa and observe its operation. The most common method is to switch the hot tub off for about 20 seconds and then turn it on again.
Table of Contents
Turn On The Lower Amp Breaker First If You Have A Hot Tub Powered By 240 Volts.
A blinking red light on the control panel may indicate it needs to be reset. If the error signal continues on the control panel then you will need to consult your hot tub manual to see what the problem is. Also, push the “jets 2” or “aux” button, if you have a 2nd pump, to turn it on.
This Is Known As A Topside Control Panel.
When the temperature of your hot tub changes outside of your range, the light will turn off. You can reset a hot tub control panel by switching it off, waiting for between 10 and 20 seconds and then switching it back on again. Know your hot tub control panel.
This Would Work On Any Hot Tub Model.
Turn off the power to the spa. Replacing a balboa control panel on a spa or hot tub. A standalone hot tub has the control panel built into the top of the tub.
This Is An Instructional Guide On How To Reset Your Sensors By Unplugging Them From The Circuit Board.
Turn on your spa and observe its operation. Remove cabinet panel, and covering for the control system. Before you call out a balboa service technician, though, try to do some.
Locate The Heater's Sensor Wires And Trace Them To Where They Plug Into The Circuit Board (Pictures Below).
This is a red button found on many spa packs. How to reset a spa heater. The most common method is to switch the hot tub off for about 20 seconds and then turn it on again.
