How To Install Blink Outdoor Camera To Mount. This adapter snaps into the opening on the back of the camera, as shown with dashed lines below. From unboxing to attaching to the side of the house, and everything in between.

Put it in a place where it could give a better view and screw it into the wall using the single screw that comes with it. You just must get the mounting clip where a hole for the screw could be seen and attach it to the camera where you should here an audible snap to keep it in place. But make sure it’s not too far up that it distorts the viewpoint.
Table of Contents
Place The Camera Under A Covering Or Awning To Prevent It From Suffering Elemental Exposure Or Water Damage.
When your camera is mounted, go to the blink app and create a thumbnail or enter live view, to know if the camera view is right, or needs to be adjusted. How to set up the blink solar panel mount 1. To find the best place to
Plug Other End Of The Cable Into The Provided 5V 1A Usb Power Supply And Then Plug The Power Supply Into Your Wall Outlet.
How to install blink outdoor. Clip the camera to the mount and position it using the live view mode. When your camera is mounted, go to the blink app and create a thumbnail or enter live view, to know if the camera view is right, or needs to be adjusted.
Put It In A Place Where It Could Give A Better View And Screw It Into The Wall Using The Single Screw That Comes With It.
Once done, it will prompt you with a tap sound. Check that it is firmly fixed and doesn’t wobble if you tug or nudge it; Click here for instructions on how to add your outdoor camera to your account.
How Do You Mount A Blink Mini Camera To The Wall?
How do i attach a blink camera to the wall? Afterward, you have to add a sync module while developing the system. This camera should easily hook up with any number of mounts, from gooseneck ones to ones that screw right into the center hole.
Use Live View For This Camera By Tapping This Icon.
Install the camera on the exterior wood trim or roof fascia. Now, carefully reattach the mounting bracket and back cover of the camera by gently pressing the same. You don’t want it to fall down once the camera is attached.