Binax Now Covid Test Instructions. Test kit reagents/cards must be at room temperature before use. Open the test card just prior to use, lay it flat, and perform assay as follows.
Remove swab and insert it into right nostril. Open the test card just prior to use, lay it flat, and perform assay as follows. Instructions to perform the test are included inside your test kit box.
Following The Instructions, The Patient Drops Six Drops Of Reagent Fluid Onto The Test Card Where Indicated.
False negative result may occur if less than 6 drops of fluid are put in the hole. Close left side of card over swab to seal it. 1using the binaxnow card when you are ready to take your self‐administered covid‐19 test, follow these directions:
For Use With Nasal Swab Specimens.
Wash or sanitize your hands. Please make sure that the card lays flat for the entire test. Carefully read instructions prior to starting test.
2.4 How Accurate Is This Test?
Make sure they are dry before starting. Instructions to perform the test are included inside your test kit box. You'll also need a video connection, either through a camera on your laptop, tablet or smartphone.
Plan To Take The Test Somewhere That's Quiet With A Clean, Flat Surface.
B.firmly brush against insides of nostril in a circular motion 5 times or more for at least 15 seconds. 3 indication 4 wash your hands 4.1 1.set up 4.2 2.open pouch and scan qr code on card 4.3 3.open card 4.4 4.apply fluid to top hole 4.5 5.open swab 4.6 6.swab left nostril 4.7 7.swab right nostril 4.8 8.insert swab into bottom hole 4.9 9.turn swab 3 times 4.10 10.peel strip 4.11 11.close card and seal If stored in a refrigerator, allow time to warm up to room temperature.
For Use Under An Emergency Use Authorization (Eua) Only.
Open the binaxnow kit to take your test carefully follow the instructions inside the box or navica opp. Test kit reagents/cards must be at room temperature before use. False negative results may occur if the nasal swab is not properly collected.